How does an Upfallshower work?
Logo | Upfall shower

Upfallshower = 2 showers in 1

The operation is simple, just like the maintenance!

An Upfall shower is possible everywhere being placed. Only water, electricity and drainage are needed.
Hot water supply: District heating, boiler, central heating or instantaneous water heater (good water pressure is required for the instantaneous water heater to work)

Operation

Step 2

The water is sucked up from the reservoir

Shower | Upfall shower
Step 3

A microfilter stops hair and dirt

Shower | Upfall shower
Step 4

The UV filter cleans the water

Shower | Upfall shower
Step 5

Warm water is added to refresh the shower water and keep it at the right temperature

Shower | Upfall shower
Step 6

Enjoy a wonderful "fall" from the large overhead shower

Shower | Upfall shower

Operation of the Upfallshower system

Disclaimer - exclusion of liability

The operation of the Upfall Shower is dependent on external factors, such as the supply of sufficient water pressure and hot water. This may vary depending on the heating system used, including (but not limited to) central heating boilers, heat pumps, boilers, instantaneous water heaters and electric boilers. Upfall Shower BV is not responsible for any defects, malfunctions or reduced performance of the Upfall Shower that are the result of insufficient water pressure, insufficient hot water supply or other external factors beyond our control. The customer is responsible for adequate installation and correct connection to a suitable water system. By using the Upfall Shower, the customer accepts these conditions and indemnifies Upfall Shower BV from any liability arising from inadequate water or heat supply.

Nice words from many satisfied customers!